![]() ![]() a.Įnter the commands necessary to transition to interface configuration mode for GigabitEthernet0/1. Step 3: Configure IPv6 addressing on GigabitEthernet0/1. Press Enter.Įnter the commands necessary to transition to interface configuration mode for GigabitEthernet0/0.Ĭonfigure the IPv6 address with the following command: R1(config-if)# ipv6 address 2001:DB8:1:1::1/64Ĭonfigure the link-local IPv6 address with the following command: R1(config-if)# ipv6 address FE80::1 link-local Step 2: Configure IPv6 addressing on GigabitEthernet0/0. This command will be discussed in a later semester. This command must be configured to enable the router to forward IPv6 packets. ![]() a.Įnter the ipv6 unicast-routing global configuration command. Part 1: Configure IPv6 Addressing on the Router Step 1: Enable the router to forward IPv6 packets. You will also practice verifying your IPv6 addressing implementation. Packet Tracer - Configuring IPv6 Addressing Part 2: Configure IPv6 Addressing on Servers Part 3: Configure IPv6 Addressing on Clients Part 4: Test and Verify Network Connectivityīackground In this activity, you will practice configuring IPv6 addresses on a router, servers, and clients. ![]() Objectives Part 1: Configure IPv6 Addressing on the Router Packet Tracer - Configuring IPv6 Addressing (Instructor Version) Instructor Note: Red font color or gray highlights indicate text that appears in the instructor copy only. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |